![]() If you are anchoring the safe to a carpet or wood floor, please take the necessary steps to cut a small hole in the carpet in order to prevent the drill bit from catching or for pre-drilling pilot holes in the wood floor. assumes no liability for any damages that may occur during this process. If the safe is to be anchored to the floor with carpet or wood, Granite Security Products, Inc. The instructions above are for anchoring the safe to a concrete floor ONLY. Place the black caps back into the holes located on the inside floor of the safe. Doing this will expand the sleeve of the concrete anchor bolt and secure the anchor bolt into the concrete floor. Insert the included (or purchased) concrete anchor bolts into the drilled holes through the bolt down holes on the inside floor of the safe.ĭrive concrete anchor bolts into the floor with hammer and tighten the nut on the anchor with a 19 mm socket and ratchet. Using your hammer drill and 5/8” concrete drill bit, drill holes in the concrete floor. Remove black caps from the carpeted base piece on the inside floor of the safe this will allow you to access the pre-drilled bolt down holes. Make sure the safe is level on the floor. If, concrete anchor bolts are not included, we recommend you use ½” by 3” length concrete anchor bolts that can be purchased at a hardware or home improvement store.) (NOTE: For Model Numbers WC-7-11 or GC-7-11, please use a ½” concrete drill bit and a 17mm socket and ratchet with included concrete anchor bolts. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |